Foot Pads Replacement Instructions
Tools Required: 2.5 mm hex wrench
Removal
- Make sure the miniPRO is powered off and the charger is not c
- Remove the following components:
- Battery
WARNING!
Press the Power Button until all lights are off to discharge any power remaining in the miniPRO.
- Steering Bar
- Steering Assembly
- Decorative Front Panel
- Rear Decorative Panel
- Using a 5 mm hex wrench, remove the eight fasteners (four per Foot Mat) shown in the picture below:
- Remove the Foot Pads
To replace just the foam pad, flip the foot mat upside- down and carefully fold back the edge of the pad. Do this all the way around the pad until it pops out of the plastic frame.
Installation
Install in the reverse order of removal.
You can purchase replacement Foot Pads Here (please select RIGHT or LEFT)