Tools Required:

  • 2.5 mm hex wrench.
  • Phillips-head screwdriver.

Removal

  1. Make sure the Ninebot PTR is powered off and the charger is not connected.
  2. Tip the unit onto its side, being careful not to scratch or mar the wheels or handlebar.
  3. Using a 2.5 mm hex wrench, remove the left two fasteners shown in Figure 1.
  4. Using a Phillips-head screwdriver, remove the remaining two fasteners.
  5. Remove the Parking Stand (Figure 2).

Installation

  1. Install in the reverse order of removal.
Figure 1: Fasteners Location on Elite and PTR Base
Figure 1.

 Elite Parking Stand

Figure 2.