Steering Shaft Metal Casing of Segway miniPRO

Tools Required: 3 mm hex wrench

Removal

  • Make sure the miniPRO is powered off and the charger is not c
  • Remove the following components:
    • Battery

WARNING!

Press the Power Button until all lights are off to discharge any power remaining in the miniPRO.

    • Steering Knee Controlled Bar
    • Steering Assembly
    • Decorative Front Panel
    • Decorative Rear Panel
    • Both Foot Pads
    • Center Console
  • Using a 3 mm hex wrench, remove the four fasteners shown in the picture below

  • Lift the entire Steering Sensor Casing with Shaft off of the base.
  • Lay the Steering Casing with Shaft upside-down on a clean surface

  • Using screwdriver remove control board from the metal casing.

Installation in the reverse order of removal.

Necessary Replacement Parts:

Metal Casing

Metal Casing with Control Board

Steering Shaft